Acceleration Phase
The technical
model during the acceleration phase of the sprint, including the start, should
have the following characteristics:
1. Acceleration is achieved by driving or
pushing with the drive leg. This requires a good forward lean-from the ground
up, not the waist. Remember that the amount of lean an athlete exhibits will be
directly proportional to acceleration. Also remember that acceleration does not
mean speed but the rate of increasing speed. If a line is drawn from the foot of
the drive leg through the center of mass, that line also should extend through
the shoulder joint and head. That line should be at approximately a 45-degree
angle from the ground.
2. The free leg will drive low and fast to
place the foot down under the body and may even fall behind the center of mass
depending on how quickly the athlete accelerates. Without proper acceleration
the athletes will stumble since they are leaning so far forward.
3. The heel recovery of the drive leg will
be very low coming out of the blocks in order to get the foot down fast in order
to drive again and overcome inertia.
4. With each succeeding drive step, the
athletes' speed grows until they reach their top speed. As speed increases
acceleration decreases, so you should observe a continuous lessening of body
lean. Upon reaching top speed, posture should be very erect.
5. Along with the stride-by-stride decrease
in acceleration, you should observe the athletes' heels rise higher as they get
into their normal sprint stride.
6. The arm action during the acceleration
phase is similar to the sprint striding phase. However, in the early phases of
the start the hands will be driven very high and forward relative to the
athlete's torso. The arms playa very important role in maintaining balance,
rhythm, and relaxation, so you should have the athlete consciously work them
vigorously.
7. As the athlete moves from the
acceleration phase into the normal stride, he/she will want to focus upon the
technical model for the sprint striding phase.
